Showing 1–24 of 30 results
-
Sale!
₹99.00 ₹39.00
- Adopt the NTC thermistor sensor, sensitivity is good
- The comparator output, signal clean, good waveform, driving ability is strong, for more than 15 ma.
- With potentiometer to adjust the temperature detection threshold
- Working voltage: 3.3 V to 5 V
- Output form: digital switch output (0 and 1)
- It has a fixed bolt hole, convenient installation
Add to cart
-
Sale!
₹499.00 ₹129.00
- Detection range: 1mm to 60 CM adjustable, the closer the performance more stable, white reflects the farthest distance.
- Size: in the control panel:42 x 38 x 12mm (length x width x height).
- Small forward: 25 x 12 x 12mm (length x width x height).
- Output interface: 6 wire interface (1234 to 4 signal output ends, + positive power, for the negative power is ground)
- The output signal: TTL level (can be directly connected to I/0 microcontroller, infrared light reflected back to the sensor induction, the red indicator light, output low level; no infrared light, the indicator light does not shine, the output high.)
Add to cart
-
Sale!
₹99.00 ₹49.00
- Digital Output Hall-effect sensor.
- Operating voltage: typically 5V.
- Output Current: 25mA.
- It can be used to detect both the poles of a magnet.
Add to cart
-
Sale!
₹199.00 ₹129.00
- Voltage – 250V
- Easy PCB mounting
- Good consistency
- Widely acclaimed
Add to cart
-
Sale!
₹129.00 ₹99.00
- Acrylic Body.
- Easy to install.
Add to cart
-
Sale!
₹199.00 ₹129.00
- Supply Voltage: 4.5V ~ 5.5V DC
- Measure Current Range: -30A ~ 30A
- Sensitivity: 100mV/A
Add to cart
-
Sale!
₹199.00 ₹129.00
- Low-noise analog signal path.
- Device bandwidth is set via the new FILTER pin.
- 5 µs output rise time in response to step input current.
- Small footprint, low-profile SOIC8 package.
- 2.1 kV RMS minimum isolation voltage from pins 1-4 to pins 5-8.
Add to cart
-
Sale!
₹999.00 ₹589.00
- Designed to extract, amplify, and filter small biopotential signals.
- Leads-Off Detection.
- Shutdown Pin.
- LED Indicator.
- Analog Output.
- 5 mm Jack for Biomedical Pad Connection.
Add to cart
-
Sale!
₹99.00 ₹49.00
- Vin: 3 to 5VDC
- Logic: 3 to 5V compliant
- Pressure sensing range: 300-1100 hPa (9000m to -500m above sea level)
- Up to 0.03hPa / 0.25m resolution
- -40 to +85°C operational range, +-2°C temperature accuracy
- This board/chip uses I2C 7-bit address 0x77.
Add to cart
-
Sale!
₹1,499.00 ₹1,299.00
- PH range: 0-14 PH
- Temperature range: 0-60℃
- Zero-point: 7 ± 0.5PH
- Alkali Error: 0.2PH
- Theoretical Percentage Slope: ≧98.5%
- Internal Resistance: ≦250MΩ
- Response Time: ≦1min
Add to cart
-
Sale!
₹2,999.00 ₹1,999.00
- Integrated image collecting and algorithm chip together, ALL-in-One.
- The fingerprint reader can conduct secondary development, can be embedded into a variety of end products.
- Low power consumption, low cost, small size, excellent performance.
- Professional optical technology, precise module manufacturing techniques.
- Good image processing capabilities can successfully capture an image up to resolution 500 dpi.
- Comes with Matching mode (1: 1) and Search mode (1: N)
Add to cart
-
Sale!
₹399.00 ₹159.00
- Detecting range: >120 degree
- Analog and digital outputs
- On-board potentiometer and indicators
- 1% resistors to make this module more reliable and precise
- Operating Voltage: 3.3V – 9V
- Board Diameter: 40 mm.
Add to cart
-
Sale!
₹99.00 ₹49.00
- High Photo Sensitivity
- Fast Response Time
- Sensitivity adjustable
- Detects a flame or a light source of a wavelength in the range of 760nm-1100 nm.
- Detection range: up to 100 cm.
- Adjustable detection range.
- Detection angle about 60 degrees, it is sensitive to the flame spectrum.
- Comparator chip LM393 makes module readings stable.
- Operating voltage 3.3V-5V.
- Digital and Analog Output.
Add to cart
-
Sale!
₹999.00 ₹649.00
- Comes with the BME280 sensor.
- Pressure accuracy of ±1 hPa.
- Temperature accuracy ±1.0°C.
- Altimeter accuracy ±1 meter.
- Humidity: +-3%
Add to cart
-
Sale!
₹599.00 ₹299.00
- Model: HX710B
- Data Output Rate:10 SPS / 80SPS
- Max. Operating Current (mA):1.5
- IC Package:16 Pin SOP
Add to cart
-
Sale!
₹199.00 ₹99.00
- Main chip: LM393, Electret condenser microphone
- Working voltage: DC 3.3-5V
- Induction distance is 0.5M
- Signal output Indication
- Single channel signal output
- The output effective signal is low level.
Add to cart
-
Sale!
₹199.00 ₹99.00
- Use IR LED and an optical transistor to detect pulsation in fingers
- Small and Compact module
- Easy to use.
Add to cart
-
Sale!
₹499.00 ₹140.00
- Based on the semiconductor LM35 temperature sensor
- Useful in detecting ambient air temperature
- Calibrated directly in ° Celsius (Centigrade)
- Linear + 10 mV/°C Scale Factor
- 0.5°C Ensure accuracy (at +25°C)
- Low power consumption, less than 60uA
- Low output impedance, 1mA current through only 0.1Ω
- With screw holes for easy installation and fixed. Aperture 2.6mm
Add to cart
-
Sale!
₹199.00 ₹149.00
- It is an integrated pulse oximetry and heart rate monitor sensor solution.
- Integrated LEDs, Photo Sensor, and High-Performance Analog Front -End
- Complete Pulse Oximeter and Heart-Rate Sensor Solution Simplifies Design
- Measures absorbance of pulsing blood
- I2C interface plus INT pin
Add to cart
-
Sale!
₹299.00 ₹249.00
- LED peak wavelength: 660nm/880nm
- LED power supply voltage: 3.3~5V
- Detection signal type: light reflection signal (PPG)
- Output signal interface: I2C interface
Add to cart
-
Sale!
₹199.00 ₹110.00
- Power Supply: 5 Volts
- Interface Type: Analog & Digital
- High Sensitivity to Alcohol & small sensitivity to Benzine.
- Low Cost.
- Stable & Long Life.
- On board Power indication.
Add to cart
-
Sale!
₹199.00 ₹149.00
- Good sensitivity to CO/Combustible Gas
- High sensitivity to Methane, Propane, and CO
- Long life and low cost
- Simple drive circuit
- Input voltage: DC 5±0.2V
- Current Consumption: 150mA
Add to cart
-
- The LM393, use of the wide voltage comparator
- Provide both digital and analog output
- Output LED indicator
- Compatible with Arduino
- TTL Compatible
- The sensor uses the high-quality FR – 04 double material, the large area of 5.5 * 4.0 CM
- Treatment of nickel plating and surface, have fight oxidation, electrical conductivity, and life has more superior performance
- The comparator output, signal clean, good waveform, driving ability is strong, for more than 15 mA;
- With potentiometer sensitivity adjustment
- The output format: digital switch output (0 and 1) and analog AO voltage output;
- Has a fixed bolt hole, convenient installation
Read more
-
Sale!
₹99.00 ₹59.00
- Open reed switch
- Working voltage: 3.3V ~ 5V
- Current: Upto 1.2A
- Comparator output, clean signal, great waveform, and strong driving ability
- Digital switch output (0 and 1)
- Fixed bolt hole for easy installation
Add to cart