Sale!

USB TO TTL UART MODULE SERIAL CONVERTOR CP2102

199.00 129.00

  1. CP2102 chip is a single chip USB to UART bridge IC. It requires minimal external components. It can be used to migrate legacy serial port based devices to USB.
  2. Stable and reliable chipset | USB specification 2.0 compliant | X-On/X-Off handshaking supported | Event character support Line break transmission | Standard USB type A made | TTL 5-pin connector | Asynchronous serial data bus | LED power, data reception and transmission indicators | Self-recovery fuse
  3. LxWxH : 42 x 16 x 6 mm
  4. CP2102 can be used to migrate legacy serial port based devices to USB. It can be used to program and/or communicate with a GPS/GSM module through AT commands. It is commonly used when microcontrollers have to communicate with computers via serial communication.
  5. USB specification : 2.0 compliant with full-speed 12 Mbps Standard USB : type A male TTL : 5 pin connector Number of pins : 5 pins for 3.3V, RST, TXD, RXD, GND and 5V Baud rate : 300 bps to 1.5 Mbps Byte receive buffer : 640 byte transmit buffer Temperature Range : -40 to +85

Description

USB TO TTL UART MODULE SERIAL CONVERTOR CP2102

  1. USB to ttl / USB-ttl /STC microcontroller programmer / pl2303 in nine upgrades plate with a transparent cover compatible with Arduino, raspberry pi, AVR, pic, 8051, etc.
  2. The USB to rs232 module based TTL provides the best and convenient way to connect your rs232 TTL devices or demo board to your pc via the USB port.
  3. Supports the following windows OSES: Windows 98se. Windows me. Windows 2000 sp4. Windows XP sp2 and above (32 and 64 bit). Windows server 2003 (32 and 64 bit). Windows server 2008 / 2008 r2 (32 and 64 bit). Windows vista (32 and 64 bit). Windows 7 (32 and 64 bit).
  4. Note: For windows 7, please use rc build 7100 or above. Windows operating system above windows 7 are not supported. Adopt imported controller pl2303hx, which can stabilize the flash with high speed.
  5. 500ma self recovery fuse for protection.
  6. Two data transmission indicator can monitor data transfer status in real time.
  7. Reserve 3.3v and 5v pin interface, easy for the DDWRT of different voltage system that need power.

Reviews

There are no reviews yet.

Be the first to review “USB TO TTL UART MODULE SERIAL CONVERTOR CP2102”

Your email address will not be published. Required fields are marked *